Talend community forum / [resolved] Component Creation Perspective Problem in both DI and MDM

jcmtalend · 2012-04-13 00:53:09

The 'Component Creation' IDE (perspective) loads properly, but there is no Component_Project window (analogous to the 'Repository' in the DI IDE) on the left side of the screen. This is the case in both DI and MDM. There is therefore no functionality in my 'Component Creation' IDE . The DI IDE works perfectly.

I assume it's an installation problem but I'm not sure.

I appreciate any help.

Thanks

Last edited by jcmtalend (2012-04-13 01:10:08)

vgalopin · 2012-04-13 01:04:49

Hi jcmtalend,

I don't see any attachment, can you try to add it again?

All versions have the Component Creation perspective, so you should be able to access it too by clicking on the Perspective button on the top right of the screen, then select "Other..." At that point you will see all perspectives accessible and the Component Creation should be in there. If you don't see it then yes it's an installation problem.

jcmtalend · 2012-04-13 01:11:54

Thanks Vincent, I just rewrote the original post because the .png upload didn't work properly. I'll try to upload it again.

Last edited by jcmtalend (2012-04-13 01:12:49)

jcmtalend · 2012-04-13 01:24:47

Vincent

Here is a smaller up loadable image. If it is an installation problem, why doe the problem exists with both DI and MDM?

Thanks

jcmtalend · 2012-04-13 01:51:08

I figured out the problem. Thanks.

Announcement

Unanswered posts

#1 2012-04-13 00:53:09

[resolved] Component Creation Perspective Problem in both DI and MDM

#2 2012-04-13 01:04:49

Re: [resolved] Component Creation Perspective Problem in both DI and MDM

#3 2012-04-13 01:11:54

Re: [resolved] Component Creation Perspective Problem in both DI and MDM

#4 2012-04-13 01:24:47

Re: [resolved] Component Creation Perspective Problem in both DI and MDM

#5 2012-04-13 01:51:08

Re: [resolved] Component Creation Perspective Problem in both DI and MDM

Board footer