You are not logged in.

Unanswered posts



Important! This site has been replaced. All content here is read-only. Please visit our brand-new community at https://community.talend.com/. We look forward to hearing from you there!



#1 2017-04-05 12:45:05

sebast
Member
146 posts

sebast said:

No url displayed when running the service - Talend 6.3

When I run a service in Talend 6.3  the url and the port where the service is available is not showed.

This was not the case in Talend 5.5.1. There the url was displayed when the service was run.

How can I see the url in talend 6.3?
Below is the picture that shows that no URL is displayed in Talend 6.3.
mini_Brez_naslova.png_20170405-0444.png

Last edited by sebast (2017-04-05 12:46:30)

Offline

#2 2017-04-05 21:43:05

vapukov
Member
470 posts

vapukov said:

Re: No url displayed when running the service - Talend 6.3

by default - localhost:8090

Offline

#3 2017-04-05 21:44:43

plumberg
Member
115 posts

plumberg said:

Re: No url displayed when running the service - Talend 6.3

  sebast wrote:

When I run a service in Talend 6.3  the url and the port where the service is available is not showed.

This was not the case in Talend 5.5.1. There the url was displayed when the service was run.

How can I see the url in talend 6.3?
Below is the picture that shows that no URL is displayed in Talend 6.3.
https://www.talendforge.org/forum/img/m … 5-0444.png

I have seen this happen when the job design becomes slightly complex from the "design perspective". Eg. Including "Run-if" triggers causes this for me.
But rest assured, the service is up at the set URL.
HTH

Offline

Board footer

Talend Contributor Agreement - Talend Website Privacy Policy